HP 215 Instant Dual Radio 802.11ac WW Access Point (JL186A)
Οι φωτογραφίες είναι ενδεικτικές και δεν ανταποκρίνονται πάντα στο προϊόν που διαθέτουμε
Παραλαβή σε 4-10 ημέρες

640,03 €
516,15 € χωρίς Φ.Π.Α

- +


Τεχνικά χαρακτηριστικά
Access point specifications

2.4-GHz (450 Mbps max rate) and 5-GHz (1.3 Gbps max rate) radios, each with 3×3 MIMO and six integrated omni-directional downtilt antennas

Advanced features
  • RF management
    • Adaptive Radio Management (ARM) technology automatically assigns channel and power settings, provides airtime fairness and ensures that APs stay clear of all sources of RF interference to deliver reliable, high-performance WLANs
    • 210 series APs can be configured to provide part-time or dedicated air monitoring for spectrum analysis and wireless intrusion protection, VPN tunnels to extend corporate resources to remote locations, and wireless mesh connections where Ethernet drops are not available.
  • Spectrum analysis
    • Capable of part-time or dedicated air monitoring, the spectrum analyzer remotely scans the 2.4-GHz and 5-GHz radio bands to identify sources of RF interference
  • Security
    • With an OpenDNS service subscription, Aruba Instant APs deliver integrated web filtering, malware and botnet protection to every device connected to the WLAN.
    • Integrated Trusted Platform Module (TPM) for secure storage of credentials and keys.
    • SecureJack-capable for secure tunneling of wired Ethernet traffic
Wireless radio specifications
  • AP type: Indoor, dual radio, 5 GHz 802.11ac and 2.4 GHz 802.11n 3×3:3
  • Software-configurable dual radio supports 5 GHz (Radio 0) and 2.4 GHz (Radio 1)
  • 3×3 MIMO with three spatial streams and up to 1.3 Gbps wireless data rate
  • Supported frequency bands (country-specific restrictions apply):
    • 2.4000 to 2.4835 GHz
    • 5.150 to 5.250 GHz
    • 5.250 to 5.350 GHz
    • 5.470 to 5.725 GHz
    • 5.725 to 5.850 GHz
  • Available channels: Dependent on configured regulatory domain
  • Dynamic frequency selection (DFS) optimizes the use of available RF spectrum
  • Supported radio technologies:
    • 802.11b: Direct-sequence spread-spectrum (DSSS)
    • 802.11a/g/n/ac: Orthogonal frequency-division multiplexing (OFDM)
  • Supported modulation types:
    • 802.11b: BPSK, QPSK, CCK
    • 802.11a/g/n/ac: BPSK, QPSK, 16-QAM, 64-QAM, 256-QAM
  • Transmit power: Configurable in increments of 0.5 dBm
  • Maximum (aggregate, conducted total) transmit power (limited by local regulatory requirements):
    • 2.4-GHz band: +23 dBm (18 dBm per chain)
    • 5-GHz band: +23 dBm (18 dBm per chain)
    • Note: conducted transmit power levels exclude antenna gain. For total (EIRP) transmit power, add antenna gain
  • Advanced Cellular Coexistence (ACC) minimizes interference from LTE cellular networks
  • Maximum ratio combining (MRC) for improved receiver performance
  • Cyclic delay/shift diversity (CDD/CSD) for improved downlink RF performance
  • Short guard interval for 20-MHz, 40-MHz and 80-MHz channels
  • Space-time block coding (STBC) for increased range and improved reception
  • Low-density parity check (LDPC) for high-efficiency error correction and increased throughput
  • Transmit beamforming (TxBF) for increased signal reliability and range
  • Supported data rates (Mbps):
    • 802.11b: 1, 2, 5.5, 11
    • 802.11a/g: 6, 9, 12, 18, 24, 36, 48, 54
    • 802.11n: 6.5 to 450 (MCS0 to MCS23)
    • 802.11ac: 6.5 to 1,300 (MCS0 to MCS9, NSS = 1 to 3)
  • 802.11n high-throughput (HT) support: HT 20/40
  • 802.11n/ac packet aggregation: A-MPDU, A-MSDU
  • 802.11ac very high throughput (VHT) support: VHT 20/40/80

AP-215/IAP-215: Six integrated downtilt omni-directional antennas for 3×3 MIMO with maximum antenna gain of 4.0 dBi in 2.4 GHz and 4.5 dBi in 5 GHz. Built-in antennas are optimized for horizontal ceiling mounted orientation of the AP. Downtilt angle for maximum gain is roughly 30 degrees

Other interfaces
  • One 10/100/1000BASE-T Ethernet network interface (RJ-45)
    • Auto-sensing link speed and MDI/MDX
    • 802.3az Energy Efficient Ethernet (EEE)
    • PoE-PD: 48 Vdc (nominal) 802.3af or 802.3at PoE
  • DC power interface, accepts 1.7/4.0-mm center-positive circular plug with 9.5-mm length
  • USB 2.0 host interface (Type A connector)
  • Visual indicators (LEDs):
    • Power/system status
    • Ethernet link status (ENET)
    • Radio status (two; RAD0, RAD1)
  • Reset button: factory reset (during device power-up)
  • Serial console interface (RJ-45)
  • Kensington security slot
Power specifications
  • Maximum (worst-case) power consumption: 14.9 watts (PoE) or 13.6 watts (DC)
    • Excludes power consumed by external USB device (and internal overhead); this could add up to 6 watts (PoE) or 5.5 watts (DC) for 5W/1A USB device
  • Maximum (worst-case) power consumption in idle mode: 8.2 watts (PoE) or 7.4 watts (DC)
  • Direct DC source: 12 Vdc nominal, +/- 5%
  • Power over Ethernet: 48 Vdc (nominal) 802.3af/802.3at compliant source
    • USB port is disabled when using an 802.3af PoE power source; for unrestricted operation with PoE power, use an 802.3at compliant source
  • Power sources sold separately
  • When both power sources are available, DC power takes priority

180 mm x 180 mm x 45 mm

  • 610 g
Εγγύηση Lifetime

30 προϊόντα στην ίδια κατηγορία: